Ford or Mercury vehicles customers call 1—800—241—3673;. Vehicle Curb Weight — is the weight of your new vehicle when you picked it up from your authorized dealer plus any aftermarket equipment. The tire suppliers may have additional markings, notes or warnings such as standard load, radial tubeless, etc. Available engines are the lightweight, high-efficiency 2. Go to the front of the vehicle and release the auxiliary latch that is located under the front of the hood.
The switch can also be activated through sudden vibration e. If the dissimilar spare tire or wheel is damaged, it should be replaced rather than repaired. Pull the bulb straight out of the socket. Always keep the power point caps closed when not being used. As the belt retracts, you will hear a clicking sound.
Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. Ford Focus Owners Manual Archive Welcome to Focus Planet, your total Ford Focus information center. Such products could contaminate the side airbag system and affect performance of the side airbag in a collision. Speed sensitive volume: Radio volume automatically adjusts according to vehicle speed to compensate for road and wind noise. Failure to follow these instructions may interfere with the passenger seat sensing system. Hold the clutch pedal down and move the gearshift lever into the neutral position.
If the procedure needs to be repeated, you must wait 30 seconds. Remove the jumper cable from the ground metal surface. See Guarding against exhaust fumes in this chapter for more instructions. Special instructions For your added safety, your vehicle is fitted with sophisticated electronic controls. Side airbags are designed to inflate in side-impact collisions, not roll-over, rear-impact, frontal or near-frontal collisions, unless the collision causes sufficient lateral deceleration. Gently pull the lamp assembly away from the vehicle.
Do not add friction modifier compounds or special break-in oils during the first few thousand miles kilometers of operation, since these additives may prevent piston ring seating. Pull the bulb straight out. For example: Bounce back can be used to overcome the resistance of ice on the moon roof or seals. These comments should be read and observed. If the retractor is not locked, unbuckle the belt and repeat Steps 2 through 9. Ford Motor Company and Ford of Canada do not access event data recorder information without obtaining consent, unless pursuant to court order or where required by law enforcement, other government authorities or other third parties acting with lawful authority.
. Have the vehicle checked by your authorized dealer. Refer to the Maintenance product specifications and capacities section in this chapter. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail. Press and release this control to decrease the vehicle set speed in small amounts by 1 mph 1.
Put the indicator back in and ensure it is fully seated. Furthermore, due to printing cycles it may describe options before they are generally available. Automatic transaxle fluid dipstick if equipped 8. Refer to Fuses and relays in the Roadside Emergencies chapter. Press again to stop scan function. The foglamp indicator light will illuminate. To access this information, special equipment must be directly connected to the recording modules.
If any light remains on after starting the vehicle, refer to the respective system warning light for additional information. The following table tells you which transmission or transaxle each code represents. Away from home If you own a Ford or Mercury vehicle and are away from home when your vehicle needs service, or if you need more help than the authorized dealer could provide, after following the steps described above, contact the Ford Customer Relationship Center to find an authorized dealer to help you. Close the hood and turn off the lamps. Use of a non-approved automatic transmission fluid may cause internal transaxle component damage. Turn off the engine and remove the key. The flow of fuel through a fuel pump nozzle can produce static electricity, which can cause a fire if fuel is pumped into an ungrounded fuel container.
Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. To reset the switch, refer to theFuel pump shut-off switchin theRoadside Emergencieschapter. Replace wiper blades at least once per year for optimum performance. Open the reading lamp assembly. Washer Pull the lever further to operate the washer.