Do this slowly, as it does take the oil some time to get everywhere it needs to get to. I'm definately going to get one for the next time - would be sooooo much easier. Yes I did another one recently and it is fiddly to say the least. Frequency - Every 20,000 miles or 2 years every second service. Notice: Set the brass bar on the notch. Is this a normal or necessary operation? If their weren't some merit to changing diff fluid, why do most axle and gear vendors and install shops recommend a fluid change within 500-1,000 miles of a gear swap? The rear is easy without it.
The vehicle was taken to downeast Toyota in brewer, maine for diagnostic testing on July 6, 2017, but the failure could not be duplicated. The noise occurred without warning. No if you look at the 7th photo you will see I crawled in from the front. The hardest part I had was putting the new fluid bad in with a hand pump. I replaced the gasket ,but have seen on here that some were able to reuse the original one as long no tears or cuts. Install sliding roof drive cable Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them. I see you've not mentioned gearbox - already done, or easy enough to suss out yourself? It is not necessary to have the vehicle level fill the unit to the level plug if you measure the in and I find the best way is with those half litre bottles which have a scale on the side.
I'm taking it to the dealer for an engine oil change in the morning and they said they would inspect the fluids to see if I need it changed. I think it's a good investment to change all fluids to synthetic. Dtc b1788 is also output when the front seat rh is subjected to a strong impact, even if an actual acci. The vehicle was not repaired. The tires have been worn unevenly due to rear suspension being loose causing this failure. I would be greatful for your advice. It takes a 10 mm hex socket and some muscle to remove.
The root cause of the issue is the rear differential vent on top of the assembly. Recommended viscosity: sae 90 Standard oil grade: hypoid gear oil sx api gl-5 Standard differential oil capacity: 0. Contacting Toyota customer service via letter to request reimbursement for the differential coupler that I had to have installed since so many Rav4 owners have had this same issue and others have had theirs repaired at no cost to them. Have your drain can ready and in place to catch old oil: I recommend letting oil drain for at least 30 minutes. Hint: Use the same procedures for the rh side and lh side. It was exactly enough to do the front and rear. At this time we are being told that it is not covered under any vehicle warranty or recall.
Sst 09950-40011 09951-04010, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011 , 09950-60010 09951-00320, 09955-04071 Notice: Before using sst center bolt 09953-04020 , apply hypoid gear oil to its threads and tip. Sst 09950-40011 09951-04010, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011 , 09950-60010 09951-00320 Notice: Before using sst center bolt 09953-04020 , apply hypoid gear oil to its threads and tip. Changed mine out this weekend at 20k. Had growling noise in rear in 2017. Notice: If the reference pressure difference between the first and second checks is greater than the specification, all the dtcs relating to the reference pressure p043e, p. Hint: Performing this drive pattern is one method to simulate the ect's malfunction detection conditions.
Castrol still say Refer to Dealer. Realy clear and easy to follow. The approximate failure mileage was 141,203. The dealership is telling you to change it at 60k in hopes of getting you to pay them to do it. But the front you can put the bottle up in the fender well and the hose will go to the diff. Emitting an awful noise and getting worse. Other materials: On-vehicle inspection Inspect day time running light relay Remove the no.
Most of the Rav4s with the issue have multiple seal leaking both axle seals and the front pinion seal. For the above differential both axle seals and the front pinion seal behing the magnetic coupler were replaced along with the updated vent. It will take about a half quart to fill the rear differential when empty. Break it loose by turning counter clockwise. Tighten down to 28 ft-lbs of torque: Wipe down differential of any spilled oil and recheck both plugs for correct tightness. Can I ask you a queation about auto box change? The vehicle was taken to an independent mechanic where it was determined that the rear differential coupler failed and needed replacement.
Had rear differential coupler sub assembly replaced under warranty enhancement. This vehicle has 34k miles on it. Told not safe to drive. If you buy the parts from a Toyota garage that is another good record. If you don't have a torque wrench use common sense being careful not to strip the threads.
You need a 10mm allen key; Add some more of the same as the transfer box - 0. You don't want to remove the Drain Plug first and drain all the oil only to find out you can't get the fresh oil back in. It will make sense once you start! Many people do this to get shavings from break in period out of the system. Then you can squeeze it into the diff that way. Just insert the hose into the fill hole until oil starts backing out. It just happens that this part of the driveway keeps the vehicle level while parked on the ramps: Make sure you have all the supplies and tools for the job.
No sign of a potentially dangerous situation. I backed the car out of the garage and put the rear wheels on wooden blocks and the fronts as far up the ramps as to make it level. I noticed an oil leak coming from the rear differential. When checking the fluid level on any axle, variations in the readings can be caused by factory fill differences between the minimum and the maximum fluid volume. Wasn't that bad of a job. Notice: Do not loosen the nuts.