If you want tremendous satisfaction out of your car or truck, you'll figure out that good parts make for great performance - PartsGeek. I wanted to match the color it so that it looks nice and buy a 6000K colored bi-xenon bulb. Wiggle and see if you can remove it, if not then I'm afraid you'll have to drop your bumper, or at least one side of it in order to pull it out. I have the 2004 E46 sedan - facelift version and has the bi-xenon bulbs. Use of the replacement bulb size information is at your own risk. The factory bixenons have a flap built in that flips up when the high beam is engaged and uses the same bulb.
Thanks Although I cannot reply to all of your questions, I just went through the drill of replacing the right headlamp xenon ignitor which entails removing and disassembling the entire unit just to reach teh offending component. Maintaining a vehicle with the best parts is the best strategy, time after time. Any suggestions would be much appreciated. Oct 26, 2014 Jun 16, 2010 Apr 10, 2007 Oct 30, 2006 Nov 23, 2015 if it was me and did not have any problems with the one i have now i would keep the one i have this is what i do before i change cars i get on and checkout the price different to see if the new car is going to cost me more in parts like a alternator and i wish you the best Michigan Man. Last thing you want are scratches on it. What kind of bulb would I need. Then the lower trim below the head lamp has to be pulled out, those are held in by a plastic tang on a plastic hook.
There is just one more trick to this. I recently installed an Umnitza Orion V2 angels eyes - a very tedious installation that took me almost a day. Which brings me to the following questions: 1. You will need to remove the turn signal first. If it's anything similar to my Audi, there is a cover on the back of the headlight housing that you pop off. And two more near the back of the assembly, near the area where you would change a headlight bulb.
From what I understand about bi-xenon is that the low and high beam are in the same bulb already. Four 8mm screws respectively hold in the head lamp. If you want to leave it on when removing the light, it is also ancord in at the fender corner. Is there any suggestion on what brand is the best that has the 6000K color? Here is what a 6000k setup looks like once installed: 6000k on the left, 4300k on the right. If you want to leave it on when removing the light, it is also ancord in at the fender corner.
And two more near the back of the assembly, near the area where you would change a headlight bulb. AutoZone features high-quality headlights from some of the industry's best brands, so you can bank on premium quality when you shop with us. Two located right on top of the head lamp and two more below. Question is where they are and how to get to them. There are two bolts on top of the headlight assembly. From what I understand about bi-xenon is that the low and high beam are in the same bulb already.
Apr 11, 2009 There are 2 8mm screws on the top of the headlight and 2 identical looking screws on the backside of the headlight assembly you will need about a 6 in extension for those 2. At least in the 330 Ci which I suspect uses the same headlight assembly as yours , you merely snap off and remove the round cover on the vertical surface just behind the xenon bulb lamp no need to remove the headlight assembly - although you may want to remove the air cleaner box to improve access on the driver's side. The trim is anchored toward the center of the car and can be released by pressing the tab in. Jul 30, 2009 The E46 2001 325i headlight assembly is held down by 4 bolts. Skin oils can cause a halogen bulb to burn very hot and burn out very quickly. If you see a tab in hole, carefully press down while pulling turn signal out. I don't have experience with a resistor setup in this application but you can go with a set of our Xenesis bulbs which are a hypwerwhite replacement to upgrade the color.
Then the entire headlight assembly including the turn signal can be slided out together. Which brings me to the following questions: 1. There are two bolts on top of the headlight assembly. Any suggestions would be much appreciated. Broken or malfunctioning headlights lead to getting pulled over by the police, or worse, a collision in the dark of the night. If you see a tab in hole, carefully press down while pulling turn signal out. The 4 bolts require a 10mm wrench.
The trim is anchored toward the center of the car and can be released by pressing the tab in. The 4 bolts require a 10mm wrench. Adding More Information If you would like to help the Modified Life community by adding any missing information or adding a new light bulb size information to our resource, please feel free to or post it at the bottom of this page. In the center of the opening revealed by removing the plastic cover mentioned above, you will see a red connector that attaches to the back of the xenon bulb - give it an easy twist I think clockwise from the front - but should not be hard to twist off. You have to unhook this.
Then you can reach in, pull the wire connector off the bulb, and unclip a metal retainer over the bulb, and pull the bulb out. Then you will see the tail end of the xenon bulb, which is retained in the housing by a gray-black retainer ring which you gentry twist to loosen. Select Same Day Store Pickup when ordering online for quicker access to your purchase, and we also provide home shipping. Is there a thread that provides a complete bulb replacement with some pictures provided? I recommend our which replace the factory bulbs with a pure xenon white. Since you say that you spent a day installing angel eyes, I would think that replacing the xenon bulb would be fairly easy. Directly under the headlight assembly you might have a painted trim piece.
I have the 2004 E46 sedan - facelift version and has the bi-xenon bulbs. Feel free to use any replacement light bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. Installing our 325i headlight is easy, and we even offer a Loan-a-Tool program to make sure you have what you need to do it. The E46 uses a D2S bulbs and I do recommend the 6000k for a pure white output 4. Installation of the new one is the reverse.